Hoping someone can steer me in the right direction, after years of flawless service I recently moved my 990 to a new house. Everything seemed ok but now I have issues where sometimes the remote doesn't do anything, the 990 simply doesn't respond to any commands. I know the obvious is batteries, etc but I changed them and I also have a 2nd remote, a logitech Harmony and when the problem occurs neither work, not even on/off works, then, magically it starts working again with both remotes. I even tried putting the remote inches from the sensor, tried with all the lights and blinds closed in the room and it made no difference. When the problem does occur I also tried the hard buttons on the unit itself and they DID work. I'm wondering if the IR sensor on the outlaw unit could be going bad or if this could possibly be software related. I currently have the most updated firmware on the unit.

I'm at a loss, I still love this receiver but with it acting so flaky I'm not sure what to do short of sending it to outlaw for repair (if they still repair the units)

Thanks in advance,

Rob