Dear friends,

Some of you, such as Gonk and XenonMan have answered some of my doubts recently. I must remind you my system:

Outlaw 990 + 7125. Also a DVD player with 5.1 analog connections.

Yesterday I tried to "lauch the system" for the very first time. I was really excited about it, but unfortunately I did not reach my goal. I feel really frustrated, because, apparently I did follow the steps recommended in the Owner's Manual. Perhaps you guys could help me out, to figure if I am missing something.

I hooked the DVD 5.1 in the 7.1 audio in. I also hooked the DVD in the OPTICAL 1, for alternative audio testing.

So what is the main problem?

For some reason I cannot run the AUTO SETUP (pages 26 and 28). I connect the omnidirectional microphone, go thru all screens to get to the AUTO SETUP, and when I am there it no let the "Start Setup" change to YES in order to run the SETUP. I do not know what to do. I should also inform the following I have tested:

FIRST: I did a CHANNEL CALIBRATION (page 30) and in this case worked fine. I could hear the testing through each speaker connected to the 7125.

SECOND I tried to listed the CD from my DVD device, using the HEADPHONE (page 38). It worked just fine.

PLEASE SOMEBODY HELP ME.

Best regards to all,

Cadu