Greetings,

Just setting up a 990 Prepro. Everything seems great, but DVD function. Running v3.11 firmware.

Having trouble getting video from new DVD (Oppo 971) player ... which duplicates problen with older Sony DVD player. New component cable "ohms out" OK, and works as a composite + 2-Ch audio connection.

1. Question. During Setup, if a valid video connection is temporarily selected in one of the SETUP menus, should the video from a running DVD player immediately appear along with the on-screen display?

2. I.ve tried running the component cables through both Video 1, & Video 2, inputs with the same negative results. Of course permutating through all the possible component inputs after each change of cable connectors. It acts like a dead video amp after the video switch. Any comments?

Called Outlaw about 4:30 PM EDT, but they had already pulled the plug for the day.

Regards to all,

Frank