I bought a nice Niles AC-3 box that switches a couple of 110V AC outlets on and off with a 12V DC trigger. I was going to use this for the built-in 110V AC fans in my rack. Well it turns out to not work with the Outlaw 990. The Niles requires 100mA, which is a bit high, but I thought the 990 could handle that. I measured 12V DC out of the Outlaw when switched on - so the Outlaw was working right. I found a 12V DC 90mA wall wart - it DID work with the Niles, so the Niles was working right. I just wish the Outlaw was spec'd in the manual for current output on the triggers.

I thought I'd share this experience with you all, so you didn't go through this.