I've had my 1050 for a number of years now, and recently started experiencing a problem where the sound cuts out. I can usually hear the click of a relay or something when it does it, and it then goes back on with another click about 10 seconds later. It usually only does this when its been on for a short time, once its been on for a while I don't have a problem.

I should say that I only have the center channel hooked up through the amp section, the fronts go through my tube amp, and I took down my rear speakers when I painted the room earlier this year and just haven't put the wiring back up. This has only happened when I've used the Outlaw without turning on the tubes, although I may not notice it with the tubes on. I would think then that this is an amp stage problem, but wouldn't rule anything out.

I suppose I should check cabling in the back to see if anything is amiss. I haven't been behind it in a while.

I can see from the dates that this board isn't very active anymore, but maybe somebody will read this and reply.