When I'm listening to stereo music my 1050 isn't sending a signal to the sub. The sub is turned on and the icon appears on the 1050 display, x-over is set at 60Hz at the 1050. However if I turn on the center channel the sub kicks in! Turn off the center channel and the sub shuts down. I'm sure there's a simple solution to this but I just can't figure it out, anyone have any suggestions? It has always worked properly in the past.

Thanks for any help

Dave

Are your mains set to large or small? If they are set to large, you won't get anything to the sub. That may not be your solution, but it's a place to start.

------------------
gonk -- Saloon Links | Pre/Pro Comparison Chart | 950 Review

Argh! You called it Gonk At some point in my fiddling I set the mains to large and never thought about that being the problem. Many thanks, I was pulling my hair out

Dave