So far I have only used the 1050 in direct mode to get access to its independent amplifiers. I use it with lspcad for crossover emulation. To emulate a three way crossover in stereo I need six amps. So far I have not figured out how to get access to the center surround amp. In the 5.1 input section on the back of the 1050, there are inputs for 5 amps, and one labeled /sub. I don't see how to get input to the center surround amp. I have the cs amp turned on in speaker config. Any ideas?
thanks,
Rick

There is not a direct input to the CS amp. It only reproduces the material decoded from the left and right surrounds by the 1050's "Surround 6.1" processor.

------------------
gonk -- Saloon Links | Pre/Pro Comparison Chart | 950 Review

Urrrrgh. Will have to get creative now and find a way to emulate crossovers for a three way system. I have assumed all this time that I had access to 6 independent amps - a main reason for buying this unit - HT has not been the immediate reason. Thanks for answering. -Rick