Check out page 4 and the description of the trigger output jack:
When more than one Model 200 is used in an system, this jack may be used to pass the low voltage control signal through to the Trigger Input Jack of an additional Model 200. Note, however, that connecting more than two Model 200s to a single source controller may overload the system and is not recommended. If you wish to automatically turn on more than two Model 200 units, we recommend the use of either the music sense circuitry or an externally powered relay controller. Contact Outlaw Audio Customer Service for more information on using the Model 200 in multiple unit systems to avoid damage to your processor, receiver or controller.
Apparently an endless daisy-chain is not advisable, but there are alternatives.
------------------
gonk -- Saloon Links |
Pre/Pro Comparison Chart |
950 Review 
Previous Topic
Index
