Anyone run into issues with the Auto Setup not working? When I first received my 976 it worked fine. I had a bit of an issue with the amp I had. Pulled it out of storage only to find a channel was dead and when the auto setup hit that channel it would fail and say the speaker head to be connected. I just removed a few channels and it ran fine.

Tonight I hooked up a new Model 5000 amp to replace the old 5 channel and tried setup again. It’s failing on the first speaker (left front) but I clearly hear the test tones. If I do a manual test tone generation it cycles through all the channels without issue. I’m wondering if perhaps the microphone is the issue.