Thanks Helson. After reading Ben's post I was just looking for clarification. As long as we get a visual of what correction the 976 has applied getting the subs set should not be difficult.

If I have this right I would run the set up with a single sub letting the 976 make corrections for both levels and any necessary phase adjustment for the sub channel. After making note of the sub channel settings run set up again with the second sub. If the applied correction differs from the first sub then using the controls on the subs make manual adjustments to even the levels and adjust phase if necessary.

I am sure I am making this sound more difficult than it will be in practice. The Outlaws should send a few of us units so we can callaborate on best methods of set up. Hint, Hint