It's been a lot of years since I had a Model 950, so I may be forgetting something, but in analog bypass mode the stereo signals went to the left and right channels with only volume control. The sub was inactive, unless you wanted to use the 6CH input...
Gonk, I think it's been long enough that you don't remember this correctly. From page 6 of the Outlaw 950 user manual:
STEREO BYPASS button (see page 31) Defeats the DSP processing section and provides an unaltered, full-bandwidth stereo signal to the Left and Right channel outputs on the rear panel. However, the subwoofer DSP crossover remains active and bass frequencies are available at the subwoofer output should you wish to augment your front LR speaker’s low frequency performance. The word BYPASS appears in the FRONT PANEL DISPLAY. Pressing the button again returns the unit to the previously selected DSP mode.
Previous Topic
Index
