If I understand the manual correctly both "Pure Audio" and "Direct" modes will not apply any processing to the incoming analog audio signal. Therefore, any room correction will have to be done by my BDP-83 prior to sending it out the analog outputs. Is that correct? If so, could I just use all the information that 886 room correction process measured, i.e. speaker distances and db levels?
The "no processing at all" is a bit misleading. The Onkyo does still adjust speaker levels and distances, even in Pure Audio mode. Or I would be hosed, as I have about 10X the amplifier power running my L&R mains as my side surrounds.
Previous Topic
Index
