Ya, sorry about that man. I should say 14 speakers. I know it is the identical signal; you just duplicate the channels, but this method is to increase the overall volume without adding additional amplifiers. Also, additional speakers placed close to the original ones will acoustically couple so they act like a much larger speaker receiving twice the power. I found that using 2 pair of speakers for stereo sounds fuller, louder than using 1 pair. You can put that additional pair on the side wall near your ear height. It sounds better than using 1 pair. For ohm, if you connect two 8 ohm speakers per channel, the amp will see it as 4 ohm load. If you connect two 4 ohm speakers per channel, the amp will see it as 2 ohm load. That's why I said the amp will run hot by using this method. Sorry about confusing, bro.