I'm a new poster but not new to Outlaw. Had a 950 and a 990 for the last two years. I've been running a 5.1 setup and just added a rear center to wash some additional sound across the rear. My room does not lend itself to 7.1 because it is open on one side. I am using Klipsch reference speakers with Adcom and Sherbourn amps and an SVS sub. Here is my situation. I purchased a Samsung BD-P1500 blu-ray player prior to my adding the rear center. When I now run the THX optimizer with the Samsung set to PCM using optical out and the 990 on Dolby PLXII movie it does not send the test to the rears or sub but instead sums the surround and rear to the front.If I switch the Samsung to Bitstream audiophile it works fine. Finally the question. What should the 990 be set on for 6.1 and what should the Samsung be set on? Question two. When I run auto setup it sends a signal to the rear center but does not recognize it in the setup. I have to go back and manually insert it. Should I run a Y connector to the amp from the suround back output to fool the 990? Sorry for the long post and thanks.