Hello all,
I sold my 1050 only to have it damaged during shipping. The buyer said that the receiver wouldn't turn on, so it got sent back to me and that was the case. The volume knob, source selection, and mute buttons were pushed in. I took the receiver apart and pulled out the volume knob, after which, I hit the power button and the unit turned on. All of the functions seem to work fine. When I turn the power on, there is no secondary "pop" like there used to be. I hooked up a source and a speaker and sure enough, no sound. When I had the receiver in pieces, I didn't see any circuit board cracks (except in the lower corner at a screw hole) loose wires etc... so I am at a loss to find a reason as to why I'm not getting any sound. Any ideas? Thanks for any input!!!