If your sub is connected to the "Sub Output" at the back of the 950, then yes, you must set-up the front (main) speakers to small to have the low-pass signal sent to the sub.

In Stereo Bypass mode, the full range stereo signal is sent to the main speakers, regardless of a "large" or"small" speakers setting. In Bypass, with the main speakers set to small, I believe that the sub will also get the low-pass signal from the 950's digital side, as it parallel processes the signal. You will get double bass below the crossover, so you should use a low crossover point (near the bottom end of your mains) for this configuration.

And No, I don't believe you can save the settings for each Source.

Welcome to Outlaw.

Allan

[This message has been edited by AGAssarsson (edited August 08, 2003).]