1) I have a similar digital cable box, and have the same problem. One thing that you could do is set up a macro to send the digital select signal five or six times to scroll from analog to the coax input you need and a separate macro to send the digital select signal a time or two to send it back to analog...

2) There are several Pronto setups available at Remote Central , but there are not discrete codes that I know of for the digital inputs.

3) I have Paradigm Studios as well. The 100's should do well set to large, although you might also experiment with small and 40Hz. I have used 60Hz and 80Hz for the Studio/CC, and am currently using 80. I have the ADP's are at 100Hz, if I remember correctly.

4) The power button can be set up as a macro. It sounds like this has happened in your case. Check out the manual (don't have it handy on my wife's laptop), and be aware that the example in the manual has an error in it -- it describes setting up a "power on" macro and says to use the power button for each device to send the power command, even though the instructions earlier in the section correctly state to use the "mute" button to represent the power command.

------------------
gonk -- Saloon Links | Pre/Pro Comparison Chart | 950 Review