Any piece of metal wire can pass a digital signal.

That answers that and thank you. I wonder if this escalates to an issue of epic griping in the next years, is some type of conversion ‘interface’ adapter possible? Would something like this require too many hardware/software changes when your dealing with interface. Is the set path through a display for component feed just too deep and core? Even if they can? and do, my already forced usage of a RGB termination to component termanation converter (I guess that anwered my question for me if I had been thinking it through) was problematic and degraded signal and I wondered if something like that could be applied to these situations.

Not sure if converters could be applied or if hardware/firmware paths are too ridgedly set to be doable in some sort of expensive little gaget addon. And I'm guessing here? that convertors VS interface might cover two diffrent matters.

[This message has been edited by Smart Little Lena (edited December 15, 2002).]