Good morning guys and gals. I've got a question.

If I use the 950's internal test tones to calibrate all of the speakers, I come up with some reasonable trim levels for everything. However, if I use Avia, I have to bump the subwoofer trim down by about 10db to get it to match. I understand that Avia doesn't use the LFE channel for the sub but rather sends the low frequency tones through the main channels so that the 950 will route them to the sub. I can see where this is a more "real world" scenario since most of us set our main speakers to "small" and have the bass (below crossover) sent to the sub. The problem is that I have to turn the sub trim way down to get it's output to match. This is fine, except that now any information on the LFE-only channel gets cranked way down too. Any words of wisdom on this? Thanks.

Cary