ossobass has the best solution that I know of. I had to do the same thing with my previous equipment. I set the trim levels using the AVIA test tones then adjust the calibration levels to match. It's kind of a pain but at least you only have to do it once in a while.
I don't understand. On my 950 the TRIM and CALIB adjustments affect each other. If you set CALIB to -2 for center speaker, TRIM will show -2 for center speaker. CALIB provides a signal to use, and TRIM does not, but they seem to adjust the same settings.
I just finished adjusting the 950 with Sound & Vision for the following setup:
Outlaw 770
NHT 2.5i mains
NHT AC2 center
four NHT 1.5 for surrounds and back
SVS PC Plus Sub
It was curious, I couldn't see a lot of difference on the RadioShack digital meter between setting the mains at LARGE with a 40Hz crossover and setting them at SMALL with a 150Hz crossover.
Previous Topic
Index
