So I checked the settings on the Denon 2200.

Audio Channel: Multichannel
SACD: Multi
Digital Out: Normal
LPCM: Off
Bass Enhancer: Off

Further, under Multichannel all speakers are set to large and sub to Yes.

SACD - I check and it was one - nada. Switched there from various other digital modes.

Test Tones - None, not a peep... in any channel

Now, I did just play a DVD and it register as being 5.1 on the display and sounded that way as well.

I checked all the cables. They are all hooked up right. So there is either a problem with the Dennon outputting the signals or the Outlaw reading the signals. There is no problem with a stereo signal or seemingly the digital signal. Any ideas on how I can isolate which?

BTW does anyone from Outlaw monitor these posts or do I have to go over this with them in full again?

Tim