What you have can still be done, but you would need to have "pre-out" and "power section in" jacks on your receiver: a loop through arrangement in other words. This is in case you need to lower the level of only the receiver's power amp section relative to the 200. In any event if your receiver does have the power amp input jacks also, you would "Y" the "preamp out" jacks to both the input of the receiver's power amp section and the input to the 200. You would then just need to insert the outboard volume control into the line of whichever power amplifier needs to be turned down in order to match the levels between the highs and lows. This would be done at the "Y" jack if you need to insert it into the Integra's power amp line, or at the input jack of the 200 if that amplifier needs to be lowered in level.

This is really not nearly as complicated as it sounds in writing

[This message has been edited by soundhound (edited February 08, 2003).]