Trigger out

Posted by: ric

Trigger out - 02/27/18 11:55 AM

Having trouble getting the trigger output to work with 950H. I'm trying to use the M2200 monoblock in trigger mode? output from the pre to the input of the amp? is that correct?? should anything be on or off when trying to connect?? I even turned on the trigger switch on the back of the Amp. Any advise would be welcomed.
Posted by: XenonMan

Re: Trigger out - 02/27/18 08:08 PM

With the switch in the 12 volt position the M2200 should come on when the processor comes on. Make sure you are using a 3.5 mm MONO plug vice a stereo version. The mono plug has two sections, vice three on the stereo version. If that doesn't solve the issue then check the voltage of the processor output. M2200 should function with voltages between 6-35 vdc per the manual. If you want to see the manual it is still available under the products page.