1050 Factory Reset

Does anyone remember how to do a factory reset on the 1050?? I found it online a few years ago but now I can't find it again. My right channel is cutting in/out and I want to try a factory reset before I replace it.

I saw in one thread that if you unplug it and put a jumper across the prongs for 5 minutes it reset quickly. Don't know how this would work but....

Any device with a standby power on circuit, uses the microprocessor for the power on cycle. This is why unplugging the 1050 can be effective in device resetting. Don't think this would be effective for a channel issue. You may need to call Outlaw.

It is likely that if the 1050 is at fault the output caps are going bad and need replaced. Outlaw has done this in the past for a reasonable fee.