Does anyone know the dip-switch settings for the Xantech 794-10 when used with the 990 as an IR interface unit? There were some older threads on this but I could not locate the switch settings.

Thanks.

Can anyone forward this on to Scott? I read in an older post that he had the codes but I can't PM him (he does not accept PM's).

Appreciate the help.

ohiobrits,

The best way to reach me is through the contact request form on the main site. To answer your question, the DIP configuration of the 794-10 from Left to Right is as follows:

1-off, 2,3,4-on, 5-off, 6-on, 7,8,9-off, 10-on

Best Regards,

Scott

Thanks Scott,

I'll try these settings this weekend.