I have an Onkyo 886 pre amp hooked up to a Sony KDSR-XBR160 (60" HDTV) via HDMI. I also have a Sony DVD jukebox, a HD DVD player and a DirecTV Hi Def DVR which are all hooked up to my 886 via HDMI.

When watching a movie, regardless if it is a Blu Ray or standard DVD, at the end of the movie my screen often either goes completely green, completely black (no image) or the left 1/3rd of the screen goes completely green.

If I use the PS3 remote or sixaxis controller, I can hear the beeps from the PS3 XMB as I move left or right but there is no image on the screen.

If I switch sources, I get the same result.

The oonly way to fix it is to turn the 886 off and back on again. I posted this on the AVS forums, and 1 person responded that it sounded like a HDMI handshake issue.

The HDMI cable going from the PS3 to the 886 is a 4 footer from bluejeans cable, and the one going from the 886 to the TV is a 35 foot monoprice.

Here is a link to a photo of the screen turning partially gree. Scroll down about 6 posts;

http://www.avsforum.com/avs-vb/showthread.php?t=584936&page=709

Any suggestions ( I know Gonk will)?

That's an odd effect - not one I've seen with my 885 and Sony KDL-40W4100. The length of that Monoprice cable certainly creates the potential for a problem, but I'd expect it to be all the time rather than intermittent. The description fits with a problem with a handshake error. How is the video processing set on the 886 for that input? If you set it to bypass video processing on the PS3's input, I wonder if it would still happen. Or, if you've already got it set to bypass, I might try setting it to 1080p.

Can you shorten the run to the TV temporarily to see if the problem cures?

I will try and set the video processing to bypass, I never even knew that was possible. And I cannot shorten the run to the TV.

Grab Outlaw's 886 manual and check out some of the stuff about setting up inputs - I think it talks about setting video processing for each input (something that my 885 can't do).

I did, what I saw was the ability to set it to "through", instead ofa specific resolution. I will keep looking at the Outlaw guide.

It was already set to "through". I did change cables and last night it did not give me the blank or green screen.

Maybe that was it, but both HDMI cables are blue jean brand.

Who knows.....

You can get a bad cable from anybody on occasion, but it's odd that it was only intermittently bad.

If it comes back, see pages 18 and 23 of the guide to start with. If you set the resolution under "Input/Output Assign | Monitor Out" to "Source" then you can set the desired resolution for each input separately under "Source Setup | Picture Adjust". You could also set the "Input/Output Assign | Monitor Out" resolution to 1080p - in which case I think the "Source Setup | Picture Adjust" resolution doesn't need to be set because that resolution will be applied globally.

I will give that a shot. Thank you. Both cables are blue jean, I will continue to watch some movies (like I need a reason to do that!) to see if the cable takes care of it. But I will also check what you described on the pages you cited.

I watched several movies over the weekend and still no problems.

I will chalk this to a finicky cable.

Its back. I will do more "adjusting" and checking out pages 18 & 23 if see if any settings make a change.

In the meantime, I have submitted a request to Onkyo and Outlaw about a possible repair. I did not buy my 886 from Onkyo, but if they are an authorized seller I would rather ship it to them than to Onkyo (if a local shop is unable).