So I'll be be listening to music or watching a movie and want to check the channel level calibration. So I start the test tones and whip out my RS SPL and turn up the volume on the 1070 until I can actually measure something with the SPL. I turn up the volume until I am at 65 Dbs on the SPL, I fiddle around a little bit and then exit calibration (forgetting to turn the volume back down) and the volume blasts at me at a painful level because the volume on the 1070 was actually at +10, the highest it will go. So a +10 volume setting is needed to get a 65 db test tone? This just doesn't seem right. The test tones just seem so out of whack with the actual SPL when playing music or movies. I have my channel levels set to pretty much plus or minus one. Am I missing something here?