Syvlvr,

I've been having the issue where the 990 always defaults to VideoInput1 whenever I powered it on with the 880. I then would push the same activity button a second time and everything worked properly. I just followed the link above from AndrewS and the solution offered by BrentG (just over halfway down on the page) worked for me. The only difference was that for the Power Off command I did not have a PowerOff, but chose PowerToggle instead.

I followed BrentG's steps, ran to the other room, grabbed the 880 and hooked it up to the computer and downloaded the new config. Then ran back to the other room and gave it a try. It came up just as it should.
Thanks to both AndrewS for the link, and to BrentG for posting Logitech's response. Now I'll no longer have to explain to people that they need to start an activity twice to get it to work.

Jeff