I discovered that when I had laid the mic on my listening position I had the small/large issue. When I put it on the tripod it calibrated correctly each time. Though I had to tweak the sub a bit.

Shawn

I had the Mic on a tripod at head level.
I have tried 5 different phases on the Subwoofer, different sub volumes, flat response vs. video profile. Lie I said, everything is fine with the Sub removed, so it must be something the SUB is doing, but I have no idea what.

Hello All,

For those of you are experiencing issues with the subwoofer settings when using the auto calibration feature, please note the special connotation in the owner's manual regarding subs that do not have built in crossovers. If your sub is outputting a full range signal during auto setup, it will not calibrate properly. See pages 26-28 for details on proper usage of this feature.

Scott

Thanks Scott, that would explain my problem.

Hi Scott,

The SunFire Sub has a setable crossover -- It was set at 100 Hz.

Can you recommend a "proper setting" where this will work?

Thanks!

-Jeff

Whoa! The mighty Gonkster is at a loss for words! Say it ain't so! Pinch me, I must be dreaming!

Whoa! The mighty Gonkster is at a loss for words! Say it ain't so! Pinch me, I must be dreaming!

Geez, that was weird. Must have hit a time warp or something. I hit the back button on my browser and got a page expired error, tried refresh then backed up to the main saloon page. That's when I noticed I had a double post. Look at the 2 hour difference between them. Sunspots??

I seem to have something wonky going on in regards to the auto calibration.

During auto calibration it detects my Left and Right BACK Surrounds at very different distances:

LBS @ 13'
RBS @ 2'

This is consistent each time through.

As far as position from the sweet spot both are the same height and distance behind and out to the sides.

The same for my LS being a little further out due to room size. Yet for the Surrounds (L/R sides) it nails them @ 7' (LS) and 6' (RS) out from the sweet spot; dead on.

I've set the delay to match the compensation for the surrounds, bringing the LSB to 12'.

I have yet to SPL to see how accurate the Auto Set-Up is.

I got the same message until I chnaged the crossover frequency on my SunFire sub to 70 rather than the 120 I had it set to.

I am going to set it up manually with the higher corssover as I want my rears corssed over at 100Hz.