Anxiously awaiting my email for the replacement 950. One question in reading through this post. Is there a preference to setting the trim levels low and the volume high or higher trim levels with a lower volume setting to achieve calibration. I am asking this because I currently am calibrated at 75db SPL at 00db on the 950. However my trims are set at:
-8 LM
-6 C
-8 RM
-8 RS
+1RB
+2LB
-7LS
-1SW
Obviously there is not enough room to lower all of my trims by -8db. If I calibrate the 75db SPL at -10db my trims are set higher and the numbers above would probably be close to the calibration for the replacement 950 when set -8db less.

Question, what are the advantages/disadvantages in 00db and -10db calibration.

Scott