Will: If you are inputting a coax digital audio signal, choosing stereo(with your speakers set to small and a 80Hz crossover set), you should NOT get a full range signal to your front channels. I can't even imagine how this would happen since the DACs and DSP chip would be utilized for digital processing of the PCM bitstream to a stereo + sub signal.? Right? Unless... somehow, there is the parallel analog chain which occurs after the DACs and before the DSP, and that trace is the same one used for the 5.1(L/R) and 2 channel analog bypass route? Maybe... all the analog bypass setting does is turn off the DSP processing?
I hope this isn't another suprise "benefit" of the 950.

I'll try it tomorrow with my 950 and report back here...

------------------
Take Care,
merc

[This message has been edited by merc (edited July 08, 2002).]