First of all, I can't stress how nice it is to have the sub trim saved by surround mode. I have the sub turned down for stereo and up for DTS and a notch or two higher for DD. That's saved and automatic.

To change it dynamically, you press the sub button on the remote to bring up the current volume and then up and down until you are happy. This setting is temporary. If you change inputs or power down it will revert to the old setting. The same can be done for the center speaker and the surrounds.

With this you don't have to worry about the original setting since it reverts automatically. This is great for me because I can't see the OSD on component, but I can press 'Sub' and then up or down until it sounds ok and I don't have to worry about getting the OSD back so that I can reset it to the old volume.


Now that I think about it. I'm not sure if the on the fly trim settings on the 950 revert when the input is changed or the unit is turned off. I'll try it out tonight.

brianca..

[This message has been edited by brianca (edited May 28, 2002).]