#33277 - 07/02/04 11:28 AM
M&K's connected to 200's
|
Gunslinger
Registered: 07/02/04
Posts: 22
Loc: Beaumont, TX, USA
|
I have a pair of M&K LCR 750's. They are 4 OHM speakers and have power handling of 200 watts. If I were to connect a pair of M200 (300 Watts @ 4OHMs) to these, would it damage them?
_________________________
JVC RS45 108" 2.40:1 SeymourAV AT Screen Marantz SR5005 pre/pro Rotel RMB-1075 Oppo BDP-93 M&K LCR 75 mains M&K Center 750 M&K SS550 Surrounds M&K SS550 Back Surrounds Dual Epik Legends
|
Top
|
|
|
|
|
#33278 - 07/02/04 12:55 PM
Re: M&K's connected to 200's
|
Desperado
Registered: 09/02/02
Posts: 615
Loc: Northern Garden State
|
Short answer, nope!
The extra amps will be there as headroom. The only catch might be that they'll get louder faster than you expect and you'll have less usuable volume range. But otherwise, you'll be fine.
Enjoy!
|
Top
|
|
|
|
|
#33279 - 07/02/04 02:15 PM
Re: M&K's connected to 200's
|
Gunslinger
Registered: 07/02/04
Posts: 22
Loc: Beaumont, TX, USA
|
so basicly, the M&K's won't draw all 300 watts from the M200, correct? So it really wouldn't matter what the power rating on the speakers are as long as I don't crank the volume up too loud, driving the amps into distortion? Tell me if I'm even almost correct here.
_________________________
JVC RS45 108" 2.40:1 SeymourAV AT Screen Marantz SR5005 pre/pro Rotel RMB-1075 Oppo BDP-93 M&K LCR 75 mains M&K Center 750 M&K SS550 Surrounds M&K SS550 Back Surrounds Dual Epik Legends
|
Top
|
|
|
|
|
#33280 - 07/02/04 03:09 PM
Re: M&K's connected to 200's
|
Desperado
Registered: 03/21/01
Posts: 14054
Loc: Memphis, TN USA
|
Basically. In fact, the chances of damaging them decreases with additional power because the amp is less likely to hit its output limit and clip (producing nasty spikes and "junk" that is the most effective way to damage a speaker driver). With the M200's, you will basically not be able to drive the amp to distortion. ------------------ gonk -- 950 Review | LFM-1 Review | Pre/Pro Comparison Chart | Saloon Links
|
Top
|
|
|
|
|
#33281 - 07/02/04 11:51 PM
Re: M&K's connected to 200's
|
Desperado
Registered: 11/15/03
Posts: 1012
Loc: Raleigh, North Carolina, USA
|
you may just blow up your speakers if you turn your system up too loud, a small price to pay for the added benefit of nice amps. just be sure to turn volume down at end of listening or have it auto turnon to a specific volume.
------------------ This post has been brought to you by curegeorg, thanks for reading.
_________________________
This post has been brought to you by curegeorg, thanks for reading.
|
Top
|
|
|
|
|
#33282 - 07/03/04 10:17 AM
Re: M&K's connected to 200's
|
Desperado
Registered: 09/02/02
Posts: 615
Loc: Northern Garden State
|
You can also put a small fuse in-line with the speaker wire to avoid overpowering the speakers. Frankly, I find it hard to believe that the extra power of the 200's would do that unless you did something obscenely stupid.
|
Top
|
|
|
|
|
#33283 - 07/03/04 02:53 PM
Re: M&K's connected to 200's
|
Desperado
Registered: 11/15/03
Posts: 1012
Loc: Raleigh, North Carolina, USA
|
100 watts rms power over your specs for your speakers would blow them, and pretty quickly depending on media you are listening to.
im sure the peak power of the m200 is well over the threshold of which the mks can take.
however, if you listen that loudly youll damage your hearing anyway, so perhaps its best that your speakers blow...
------------------ This post has been brought to you by curegeorg, thanks for reading.
_________________________
This post has been brought to you by curegeorg, thanks for reading.
|
Top
|
|
|
|
|
#33284 - 07/03/04 03:06 PM
Re: M&K's connected to 200's
|
Desperado
Registered: 09/02/02
Posts: 615
Loc: Northern Garden State
|
Originally posted by curegeorg: however, if you listen that loudly youll damage your hearing anyway, so perhaps its best that your speakers blow...
That's basically exactly what I meant.
|
Top
|
|
|
|
|
|
0 registered (),
653
Guests and
1
Spider online. |
Key:
Admin,
Global Mod,
Mod
|
|
|
8,717 Registered Members
88 Forums
11,331 Topics
98,708 Posts
Most users ever online: 900 @ Today at 03:23 PM
|
|
|
|