Anyone out there use the M200s with electrostats?
Weight my response and I’m still early days on a lot of my notions. I don’t own electrostatics. But do feel after demo time with ML’s, - that the ML’s do greatly benefit from good/clean/unstressed power.
Without looking up the 3802 I’m going to assume it’s a receiver with built-in amps. In that scenario I think you will hear more detail out of your ML’s matching them with the 200’s and will notice an increase in the quality of their preformance.
Again not pulling up your speaker’s specs. The power sent to the speaker should never affect your choice to set them as large/small, that choice is really based on the frequency response range of the model speaker.
I have 2 mains which are technically in the stat range for setting to large but often leave them on small, for fear of their true capabilities, and assuming that I am talking load off by setting to small and creating a greater safety margin as too how hard the drivers are pushed.
As regards the Logans low range ‘fighting’ with your sub. That (I would think) should not be an issue as long as you have control of your crossovers and phase.
Previous Topic
Index