I agree! Very impressive! How long did that take you? Did you do it completely by eye?

------------------
Matthew J. Hill
matt@idsi.net

hi, everyone. that right there took me around seven or eight hours or more to do. one of the resons it took so long is that i mesured everything on my 1050 with a little ruler that goes down to the 100th of an inch scale. everything on there is pretty acurate within a few hundreth of an inch (a little more on the real big parts. so i pretty much mesured everything by hand and gussed on the stuff that i couldn't messure. thanks for apriciating my work (fun). when i get around to adding some more stuff i will post a few more pictures on that site.

youngguns, that rocks! It's probably also easier to perform a cad rotatation of the 1050 than in real life..

I didn't see the rear panel, is that your next ambitious project?

Hey jack..... yep your right, the back panel is my next project, but im not sure when i'm going to start it though. As of now it is just a plain black back. It is getting hard to work on due to the sheer size of the projecet (35mb) so think i wil desine the back panel in another file then paste it in to the 1050 file when it is done, my computer is pretty fast but it just not fast enough (hahaha).

i just posted two more pictures on the site http://www.picturetrail.com/youngguns1 they are nothing fancy, there is a picture of the binding posts on the 1050 and some rca jacks, eventually i will have these on the back of the 1050, but this is the progress so far.